What do ya think.
Ditra over plywood floor.
I put down 1 2 plywood all around in a staggered pattern being careful not to put screws in directly to the joists.
Schulter expressly notes that ditra replaces that second layer of plywood.
The subfloor is 5 8 t g plywood joists 2x12 on 12 centers.
It is 6 x7 and the floor slopes a quarter inch over the 6 width.
For installing the ditra membrane.
How to install schluter ditra on plywood sub floor.
Ditra xl allows for ceramic tile application over single layer plywood osb subfloors on joists spaced at 24 610 mm o c.
Ditra is approved for use with ceramic porcelain and natural stone tile.
Over concrete or gypsum use unmodified thinset mortar.
An uncoupling membrane does exactly what the name says.
Use unmodified thinset mortar learn about modified vs unmodified dryset thinset here fourteen months later everything looks good so far.
My bathroom floor needs some floor leveler well a lot of leveler.
Ditra and ditra xlseams and floor wall.
It uncouples or releases the bond between plywood and tile mortar allowing each surface to move independently of each other.
The concern being if the floor shifts it may buckle in areas and affect the finished floor.
Or plywood subfloor areas of application over any even and structurally sound double layer osb or plywood floor interior dry or wet areas limitations minimum 2 x 2 50 mm x 50 mm tile requirements maximum spacing of i joists or floor trusses.
This house is over 70 years old and the 1 4 boards were in good condition.
A tight unmoving bond between mortar and subfloor causes cracking.
Can be installed on top of concrete plywood osb gypsum existing vinyl floors structural planks sub floors and radiant heated floors.
My question is can i install the ditra over the floor leveler or do i put down another layer of plywood 1 4 first.
It can be installed over a variety of substrates including plywood osb existing vinyl structural planks and concrete.
Over plywood or osb use modified thinset mortar.
All the specifics for ditra installation are in the handbook or on schluter s site.
But again this tutorial is just for wood subfloors.
Ensure subfloor panels are level and properly fastened to the joists.
The joists are rough cut 2 x 8s.
For this project the ditra is being installed over radiant heating element embedded in self leveling mortar.