Starting from the left side thread one ring through the holes of both the curtain and the liner.
Double shower curtain rod installation instructions.
The method may vary by manufacturer.
Then install the rod and place a level across the length of the rod.
Spring loaded or spring tension shower curtain rods are a quick solution to getting your shower splash under control or brushing up a less than.
How to install spring loaded shower curtain rods.
Rotate the wall plate until it fits flush with the end of the rod.
There should be no gap between the base of the wall plate and the end of the rod.
Straight double shower curtain rod installation 5.
In this video we walk you through the steps in which you need to take to install your kenney double curtain rod in your home.
If not trim with a hacksaw.
Extend the adjustable curved shower rod as needed until it is the correct length then install the other end of the rod into the bracket on the opposite wall.
If there is a stud in your mounting location use wood screws to attach the wall brackets.
Drill pilot holes for the wall anchors.
Once you find the proper height level the shower rod.
Before installing installation curved double shower curtain rod pencil level tape measure screwdriver drill hammer hacksaw drill bit 1.
Once level have an assistant mark where the rod intersects the other wall.
For rods 84 and longer assemble with the connector piece.
Continue threading until all 12 rings have been threaded through all 12 holes.
6 with the fronts of the 2 covers facing together slide the covers onto the rod see figure c.
Thread the shower curtain hooks rings through the curtain and liner.
Lay the rod sections on the floor.
Place the wall brackets onto the ends of the shower rod and tighten the set screws secure.
Attach the rod and brackets to the wall with the mounting hardware provided.
Install the first bracket by screwing it into place.
Verify that the rod sections are the proper length for your installation.
7 slide the 2nd wall plate into the rod as shown below see figure d.
Using the hardware that is incl.
Hold it while you level the rod.
Then move on to the next hole repeating the same process.
Install your brackets using these marks for a level rod.